Start with daily energy
There is no single panel size for an RV. First check hookups and the existing battery in the RV trip planner. If that already covers the trip, another panel may not be needed. Add up battery-side energy each day, including device conversion and idle losses where relevant. Measure loads rather than relying on the label of the RV or a lifestyle category.
Panel watts to replace one day’s use = daily Wh / (peak sun hours x retained-energy factor).
Our example uses 4 peak sun hours and a 70% retained-energy factor. These are editable planning assumptions, not a US average, a forecast or a measured panel result. The factor is the share of the ideal energy we count after panel-to-battery losses. It is not the panel’s cell efficiency.
Worked examples, not measured setups
| Assumed daily energy | Panel watts, rounded up to 50 W | Nameplate battery for 1.5 days |
|---|---|---|
| 800 Wh | 300 W | about 1,340 Wh |
| 2,000 Wh | 750 W | about 3,340 Wh |
| 3,500 Wh | 1,250 W | about 5,840 Wh |
The battery column divides the stated battery-side daily energy by a 90% nameplate planning budget. It does not claim 90% reaches AC devices. Device conversion losses belong in the daily energy input, and must not be applied twice. Actual usable energy depends on the battery, output path, temperature and load. The panel column replaces a day’s use under the stated conditions. It provides no reserve for a cloudy stretch and does not prove that the array fits the RV or is electrically compatible.
Choose sun hours for your location and season
Peak sun hours express daily sunlight as equivalent hours at 1,000 W per square meter. They are not daylight hours. PVWatts provides location-based production estimates for grid-connected systems, not a guarantee for a shaded campsite or a portable battery setup. Use location and seasonal information as a starting point, and account for your panel angle and local shade. Avoid counting a yearly average as a winter-outage promise.
In our model, 400 W x 4 hours x 0.70 = 1,120 Wh per day. Changing the assumed sun to 2 hours gives 560 Wh. These are calculations, not forecasts.
Portable or roof-mounted?
Energy need alone cannot decide. Compare available roof area, total panel size, safe mounting, shade, setup effort, storage, theft risk and the controller’s input limits. A portable array can be larger than a roof array; neither wins at a fixed wattage threshold.
Before buying, check the battery/controller manual for allowable panel voltage, current and power, including cold-weather open-circuit voltage and wiring limits. A matching connector is not proof of compatibility. Have a qualified RV installer check a permanent system.
Limits
This is an energy budget, not an installation design. It does not calculate wire sizes, fuses, mounting loads, surge power, battery chemistry limits or a safe series/parallel arrangement. We have not measured the example loads or tested the equipment. Keep a separate plan for essential loads when solar production is low.