EssentialWatts
Menu
Independent planning, with direct manufacturer references. No purchase required. How links work.

Home / Solar

Solar charging: daily energy vs panel watts

Use panel watts, peak sun hours and a labeled loss assumption to estimate daily charging energy.

Try the solar energy calculator

Watts are not daily energy

A panel’s watt rating is measured at standard test conditions, including 1,000 W/m² sunlight and 25 C cell temperature. DOE explains that field conditions differ and production depends on sunlight, temperature and the system. A watt rating alone does not tell you what reaches the battery in a day.

For a rough energy budget:

Daily energy = panel watts x peak sun hours x retained-energy factor.

We use 70% as an illustrative panel-to-battery loss assumption, not a measured portable-panel rate. The calculator lets you edit it. Do not treat the factor as panel cell efficiency or a promise for a particular product.

Assumed panels At 4 peak sun hours and 70% retained energy
100 W 280 Wh/day
200 W 560 Wh/day
400 W 1,120 Wh/day
800 W 2,240 Wh/day

Four sun hours is an example, not a national average. Use the location and season you intend to travel in. PVWatts models grid-connected production, so its output should not be presented as a direct prediction for a portable battery setup.

A refill is not the same as replacing usable output

For a nominal 1,000 Wh battery and 400 W of panels, an idealized refill calculation is 1,000 / (400 x 0.70), or about 3.6 equivalent peak sun hours. That is not 3.6 hours on a clock. It assumes all modeled energy is available for charging, no simultaneous loads and no input clipping or charge taper. Real charging can take longer.

The usable battery-side planning budget belongs in a separate autonomy calculation; device conversion losses are separate again. Multiplying capacity by 90% before estimating a full recharge would understate the energy needed to fill it.

Check compatibility before connecting

Read the power station’s solar input voltage, current and wattage limits and the panel specifications. Account for cold-weather open-circuit voltage, polarity, approved cables and series/parallel arrangements. A wattage ceiling may clip output, but excessive voltage can be unsafe. Do not add panels on the assumption that the station will safely reject everything it cannot use.

Shade, panel angle, temperature, controller behavior and cable losses can change results. We have not tested the panels or charging rates. Measure your own system, and keep reserve capacity for poor production days.

Source/editorial record: 2026-11-22. Draft presentation and shared calculation method revised November 22, 2026.

Related

Sources (2)